Microchip | MCP4716A2T-E/CH

The VREF pin or the device VDD can be selected as the DAC’s reference voltage. When VDD is selected, VDD is connected internally to the DAC reference circuit. When the VREF pin is used, the user can select the output buffer’s gain to 1 or 2. When the gain is 2, the VREF pin voltage should be limited to a maximum of VDD/2.

The DAC Register value and configuration bits can be programmed to nonvolatile memory (EEPROM). The
nonvolatile memory holds the DAC Register and configuration bit values when the device is powered off. A device reset (such as a Power On Reset) latches these stored values into the volatile memory.

Features:

• Output Voltage Resolutions
  • 10-bit: MCP4716
  • 8-bit: MCP4706
• Rail-to-Rail Output
• Fast Settling Time of 6 µs (typical)
• DAC Voltage Reference Options
• Nonvolatile Memory (EEPROM)
• Auto Recall of Saved DAC register setting
• Auto Recall of Saved Device Configuration
• Power-Down Modes
• Disconnects output buffer
• Selection of VOUT pull-down resistors (640 kO, 125 kO, or 1 kO)
• Low Power Consumption
• Normal Operation: 210 µA typ
• Power Down Operation: 60 nA typ
• Single-Supply Operation: 2.7 V to 5.5 V
• I2C™ Interface
• Eight Available Addresses
• Standard (100 kbps), Fast (400 kbps), and
• High-Speed (3.4 Mbps) Modes
• Small 6-lead SOT-23 and DFN (2x2) Packages
• Extended Temperature Range: -40°C to +125°C

Applications:

• Set Point or Offset Trimming
• Sensor Calibration
• Low Power Portable Instrumentation
• PC Peripherals
• Data AcquisitionSystems
• Motor Control

View the MCP4716 family of Digital to Analog Converters